Maintaining the Control-M for SAP process

This procedure describes how to start, stop, and view the status of Control-M for SAP process.

To maintain the Control-M for SAP process:

1. Use the following directories:
   • UNIX: $CONTROLM/cm/SAP/exe
   • Windows: <Agent_home>\cm\SAP\exe
2. Type the following:
   • UNIX: sapcmbe.sh {start|stop|status|change_port|refresh|jco}
   • Windows: sapcmbe.cmd {start|stop|status|change_port|refresh|jco}
3. Do one of the following:
   • start: Starts the Control-M for SAP process
   • stop: Stops the Control-M for SAP process

   If the Control-M for SAP process was stopped and a new request for the Control-M for SAP process arrives, it starts automatically. You should note the following:

   • status: Indicates whether the Control-M for SAP process and the Extractor process are running or not.
   • change_port: Updates the TCP/IP port used by the Control-M for SAP
   • refresh: Refreshes the data collected from the XAL interface that is used for load balancing. If you do not run this command, the data is refreshed automatically on a daily basis.
   • jco: Prints the version of the SAP JCo JAR file and the version of the C library file. If one of these files is not installed correctly, an error message appears.